Online Service
Contact: Mr. Li 18681482740
Email: lilinhan1314@126.com
Website: www.boldlove.net
What are the precautions for precision hardware stamping operation?
1. Check if various precision hardware stamping equipment and materials are ready.
2. Operators and mold repairers are strictly prohibited from putting their hands into precision metal stamping molds during production.
3. When installing the suction fan, operators are strictly prohibited from reaching their hands onto the motor to clean waste materials.
4. It is strictly prohibited to wear slippers during work to prevent workshop molds, iron blocks, etc. from hitting your feet. The team leader, fitter, and mold repairman must wear safety shoes when working;
5. Male operators are strictly prohibited from wearing long hair, while female operators should curl up their long hair to prevent it from getting caught in the flywheel.
6. Other oils such as white electric oil, alcohol, cleaning agents, etc. should pay attention to fire prevention.
7. When packing materials, waste materials, and molds, gloves should be worn to avoid scratching hands.
8. When there is oil, it should be cleaned in a timely manner to avoid slipping and falling.
9. It is strictly prohibited to wear gloves when drilling and milling machines; When using the grinder, wear a mask and eye protection to protect yourself.
10. Pay attention to dragging precision hardware stamping molds to prevent them from falling off the ground (the flatbed truck needs to be lowered to transport the molds).
11. Non electricians are strictly prohibited from connecting to electricity and repairing the machine.
12. It is strictly prohibited to aim the air gun at people, as it may damage the eyes.
13. Operators need to wear earplugs.
14. When discovering any abnormalities in the machine, turn off the power first and then promptly contact the technician on duty for handling. Unauthorized handling is not allowed.
15. When a new employee starts work one day, the team leader must explain the safety operation regulations to them and study the safety operation regulations once a week every day.
16. When adjusting the machine, it is necessary to adjust the machine to single action and strictly prohibit connecting the discharge belt.
17. No flammable or explosive items should be stored under the electric switch.
18. Operators are strictly prohibited from chasing and hitting in the workshop to avoid falling, hitting products, or injuring themselves.
19. Conduct equipment inspection according to the inspection content on the equipment inspection card, paying special attention to whether the guiding and braking devices of the punching machine operate normally, and the single and continuous punching functions are clear.
20. When installing the precision metal stamping die on the small punch, first loosen the locking device of the guide rail, install the upper and lower dies, and then adjust the travel of the guide rail until it meets the requirements and locks the fastening device. In addition, when the high punch is used to mount the mold, the single stroke must be hit. After locking the upper mold, the lower mold is locked after the hydraulic mold locking, and another inspection is conducted before production.
21. When arranging or manually feeding or retrieving individual embryo materials, special tools (pliers, hooks) must be used, and it is strictly prohibited to hand feed or retrieve embryo materials. A single switch can hurt hands, but a double switch is necessary. The machine should not leak oil, otherwise it will fall off. Do not expose the power supply, it is dangerous.
22. When stamping iron sheets, wear gloves and concentrate to avoid hand injuries.
23. During work, first check if there are any abnormalities in the operation of the equipment, such as unclear single or continuous punching, ineffective operation, or electrical faults. Immediately shut down the machine and seek timely assistance from the technician on duty.
24. It is strictly prohibited to use foot switches on the punching machine, and all original equipment on the machine should be removed.
When cleaning and inspecting equipment, the power must be cut off before operation.
26. Cutting precision hardware stamping equipment